SEGGER - Alex Administrator

  • Member since Dec 18th 2007
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • SEGGER - Alex -

    Replied to the thread Open Flashloader Read past 1MB errors.

    Post
    Please note that the savebin command does not go through any flash loader routines. It simply performs a ReadMem() access from the specified address. Is your flash memory mapped readable? Or is it some kind of SPI flash etc. that is not mapped in the…
  • SEGGER - Alex -

    Replied to the thread [SOLVED] Unable to write to ECC flash on tms570lc4357 device.

    Post
    The situation is as follows: The J-Link flash loader uses the TI lib to program the internal flash of the TMS570xxx series devices. This is because TI does not publish any information about their flash controller etc. and recommends to use the TI lib for…
  • SEGGER - Alex -

    Replied to the thread Is it possible to insert comments in a .jlink script?.

    Post
    You can use C++ line comments "// Something" withing commander scripts with no problem. Example: Source Code (5 lines)
  • SEGGER - Alex -

    Replied to the thread J-Flash - CRC checksum does not compute as instructed.

    Post
    Hi, Not sure what you are trying to do. Disabling a bank in flash does not change the CRC of your data file. The data file will still hold data for 3 ranges and therefore the same CRC. If you want to remove a region from the data file, you can go…
  • SEGGER - Alex -

    Replied to the thread Problem with J-Link SWD Isolator.

    Post
    Actually, the 2 SEGGER products (J-Link EDU and SWD Isolator) are working fine together. Dozens of customers use them. It is probably the target side that is a bit problematic here. Not sure what board you use but is the board designed to also allow…
  • SEGGER - Alex -

    Replied to the thread Ozone Instruction Trace Not Working Running In DRAM ATSAMA5D27.

    Post
    Hi, Actually, what the command is pretty self-explanatory: By default, J-Link caches the download of your application on debug session start and later uses that cached contents during trace. Reading always from target memory would be too slow for…
  • We are currently working on a new multi-processing concept / solution which is expected to be completed in Q1/2020. This will then allow multiple connections via IP (if all come from the same host PC) For now, you are limited to 1 connection via IP.
  • To answer the original question: Quote from lukma: “The original question was about the possibility to emulate/generate with Segger setup the TRST and !RESET signals with micro seconds resolution. ” This is not possible right now. It may be in in a…