DenisCollis Beginner

  • Member since Jun 28th 2018
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • DenisCollis -

    Posted the thread Include unlock command in Flasher ARM.

    Thread
    Hello, Some production batches have boards which were previously programmed with 'allow security'. When I manually re-program these using J-Link Commander, I need to use the 'unlock kinetis' command before loading the file. How do I ensure that these…
  • DenisCollis -

    Replied to the thread [SOLVED] loadbin to QSPI Flash on NXP K81 fails.

    Post
    Hi Nino, I think I have everything working, if I follow the exact sequence below: The connection sequence: - insert J-Link USB - Insert J-Link JTAG - Power up boardLaunch J-Link Commander The connection is important: - J-Link> connect - Device:…
  • I need some help troubleshooting Release: J-Link/J-Flash V6.46 or V6.48 Devices: J-Link Compact or Flasher ARM I'm trying to program NXP K81 with Internal and External flash. Using both devices, with the same .hex program file this sometimes succeeds…
  • DenisCollis -

    Replied to the thread [SOLVED] loadbin to QSPI Flash on NXP K81 fails.

    Post
    Hi Nino. Oops, that was a typo! The version I am using is V6.46 and NOT V4.46 However, I did as you suggested and downloaded V6.48. I now get : J-Link>loadfile c:\nxp\termsettings.hex InitTarget() Found SW-DP with ID 0x2BA01477 AP map detection
  • DenisCollis -

    Posted the thread [SOLVED] loadbin to QSPI Flash on NXP K81 fails.

    Thread
    I am able to load firmware with code sections on both internal flash, and external QSPI flash using, e.g., loadfile FW.hex (This functionality was available from J-Link V4.44) Now I need to load a single binary data file to an address in QSPI…