SEGGER - Nino Administrator

  • Member since Jan 2nd 2017
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • SEGGER - Nino -

    Replied to the thread ETB Trace empty on Attach.

    Post
    Hello, Thank you for your inquiry. The described behaviour is expected. The debugger has to initialize ETB trace to be able to use it. For this a defined system state is needed e.g. after reset or target halt. After continuing after such defined system…

  • SEGGER - Nino -

    Replied to the thread Is there any plan for supporting wch CH32V risk V parts?.

    Post
    Note: Moved to J-Link forum as this is more a J-Link question. As soon as J-Link support is added for the aforementioned devices Embedded Studio is automatically also available. Depending on the target devices complexity it might also be sufficeint to…

  • SEGGER - Nino -

    Replied to the thread [SOLVED] Debugger problem discoverd: The debugger has set two brekpoints at the same address.

    Post
    We received the following solution for this issue from TESSY Support Team: "Message Box in Keil uVision from JLink: The debugger has set two breakpoints at the same address If you click OK fast enough, the test will still be executed…

  • SEGGER - Nino -

    Replied to the thread support RISC-V core.

    Post
    Hello, Thank you for your inquiry. SystemView is Core architecture independent and can always be used. So RISC-V is also supported. Best regards, Nino