DaveN Beginner

  • Member since Dec 2nd 2016
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • DaveN -

    Replied to the thread cannot execute this command without a live selected thread.

    Post
    Apologies Nino if I wasn't clear. Connection is AOK, but the error happens on starting debug. I've attached console output below in case that's helpful. Thanks again for the help, Best Regards, Dave Source Code (134 lines)
  • DaveN -

    Posted the thread cannot execute this command without a live selected thread.

    Thread
    Hi - I'm developing on a STM Nucleo-F413ZH Nucleo-144 Discovery board using STM/Atollic Eclipse. Because Segger doesn't provide a cable to connect my JLink to the debug header STM puts on these boards (please make and sell these!), I'm using the…