SEGGER - Martin Administrator

  • Member since Jul 1st 2014

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • SEGGER - Martin -

    Replied to the thread [SOLVED] Can not compile or run embos on stm32f103rbt6.

    Post
    Hello Ali, Okay, so you're including the STM32Cube HAL directly from within Keil MDK. This combination is not something I have used before and since neither product is supported by SEGGER, I'm afraid I can be of limited help here only. However, I'd…
  • SEGGER - Martin -

    Replied to the thread [SOLVED] Can not compile or run embos on stm32f103rbt6.

    Post
    Hello Ali, I'm not quite sure about your set-up in this particular case. SEGGER.I-CUBE-embOS_conf.h should be generated by STM32CubeMX when creating a project that was configured for embOS. However, it seems the *.ioc file included with your project…
  • SEGGER - Martin -

    Replied to the thread [SOLVED] Can not compile or run embos on stm32f103rbt6.

    Post
    Hi again, Quote: “Also Please note that my keil version is 5.38 and I'm using arm compiler version 6.19 and I have also tried to compile your STM32F103_STM32_SK example, and I would get the compilation error like this (...) Setup/Retarget.c(345):…
  • SEGGER - Martin -

    Replied to the thread [SOLVED] Can not compile or run embos on stm32f103rbt6.

    Post
    Dear Ali Asadzadeh, Thanks for your inquiry. I assume you are following our Wiki page on creating CMSIS-based projects with embOS? In that case, adding the EXPORT directives you have mentioned to the start-up file is the correct solution to the…