Ewout Boks Beginner

  • Member since Feb 28th 2014
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • Ewout Boks -

    Replied to the thread STLink conversion utility for STLink v3.

    Post
    Thanks, I'm looking forward to it! The G4 Nucleo board has a separate mini SWD connector that (through a converter) can be attached to my regular JLink-Pro, So, even when the conversion utility is not ready yet, the board can be used with a standard…
  • Ewout Boks -

    Replied to the thread STLink conversion utility for STLink v3.

    Post
    Hi Nino, thank you for your reply! What about J-Link support for the STM32G4 series? I could not find it in the list of supported devices.
  • Ewout Boks -

    Replied to the thread STLink conversion utility for STLink v3.

    Post
    In addition to what I wrote earlier, I saw on the list of J-Link supported devices that the entire STM32G4 is not supported (yet) by Segger. Again, I appears I am very early in adaptation cycle. The STM32G0, another new branch of the STM32 family, is…
  • Ewout Boks -

    Replied to the thread STLink conversion utility for STLink v3.

    Post
    Hi, I must have been one of the first users then! I bought it at Mouser : nl.mouser.com/ProductDetail/ST…vJTDTT%2FJyROByOTyeQMSnwm I really like the new chip STM32G4 for its signal processing capabilities so that was why I wanted to get one for…
  • Ewout Boks -

    Posted the thread STLink conversion utility for STLink v3.

    Thread
    Hi, today I received a new board from ST (STM32G474 Nucleo-64). It contains a new debugging front-end called STLink v3. I could not convert the STLink to J-Link using the existing tool, which I reckon is only for STLink v2 ;( . "Preparing for FW…