ph99004 Community Member

  • Member since May 5th 2021
Last Activity

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • ph99004 -

    Replied to the thread [SOLVED] J-Link Debug Fails.

    Post
    Alex, Problem solved. Reset all breakpoints. There is a bug in KDS. A few people have experienced the same problem. Clearing all breakpoints resolves the problem. Thanks. Phil
  • ph99004 -

    Replied to the thread [SOLVED] J-Link Debug Fails.

    Post
    Thank you, Alex. I appreciate your help with this issue. I enjoy using Segger products and will look closely at the Ozone as an alternative. Best regards, Phil
  • ph99004 -

    Replied to the thread [SOLVED] J-Link Debug Fails.

    Post
    Alex, Thank you. I am just looking for a resolution. The JLink is connected to the host pc via USB and not TCP/IP. The system works fine while in the programming stage but fails during debug stage. Regards, Phil
  • ph99004 -

    Replied to the thread [SOLVED] J-Link Debug Fails.

    Post
    Anything you guys can suggest would be most helpful. I really need to use this debugger the way it was designed, not just as a programming tool. Please advise.
  • ph99004 -

    Replied to the thread [SOLVED] J-Link Debug Fails.

    Post
    Fabian, I am trying to program a NXP/Freescale MK64FX512VLL12, Cortex M4, using KDS (Kinetis Design Studio, V3.2.0). I have used these Jlink debuggers for years with this IDE for years. BTW, this happens with two separate Jlink…
  • ph99004 -

    Replied to the thread [SOLVED] J-Link Debug Fails.

    Post
    Fabian, Unfortunately, no difference. I have attached an updated log file using the new drivers. Let me know if there is anything else I can do to track down this problem. For example, should I entirely remove the drivers and reinstall? Thank you,…
  • ph99004 -

    Replied to the thread [SOLVED] J-Link Debug Fails.

    Post
    Fabian, Thank you for your kind reply. Attached is the log file, per your request. I am using the Jlink within the Eclipse-based NXP Kinetis Design Studio, Version: 3.2.0. I use it to program NXP/Freescale Kinetis MCUs. I am connected with a 10-pin…
  • ph99004 -

    Posted the thread [SOLVED] J-Link Debug Fails.

    Thread
    Folks, I am unable to use the Segger Jlink V9.3 to debug my embedded C code. I am able to program my MCU but when it tries to debug the Jlink crashes and MCU does not get properly restarted. I have tried two different J-links and both fail. I have…