[SOLVED] Data Breakpoint does not stop execution

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Data Breakpoint does not stop execution

    Dear all,

    i want to use the data breakpoint feature. As soon as data is written to a specific variable, Ozone should stop the execution.
    Inside watch, i see that the variable, the data breakpoint is assigned to, changes the values. But Ozone does not stop execution. See also attached screenshot.

    Can you please tell me what i'm doing wrong?
    Best Regards
    Dirk
    Images

    • DataBreakPoint.png

      25.26 kB, 774×496, viewed 199 times

  • Hi dirk.gehring,
    did you read the section 5.9 in the user's manual? Did you set all fields accordingly? Does your hardware support data break points? If so, could you please provide a J-Link log as well as an Ozone log recorded during the same session where you reproduced the issue?
    Creating an Ozone log is described in section 8 of the user's manual, creating a J-Link log is described here: wiki.segger.com/J-Link_DLL#Enable_J-Link_Log_File
    Best regards
    -- AlexD
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.