Hi,
In our system, we have modified
If we configure SystemView to use any RTT channel above 0, communication with the target works as expected.
Could you please confirm whether SystemView is unable to use RTT channel 0, or if there are additional configurations required to enable this functionality?
Thanks in advance for your support!
In our system, we have modified
SEGGER_RTT.c
to disable RTT channel 0, which is typically dedicated to the RTT Viewer Terminal. This allows us to assign channel 0 to SEGGER SystemView. However, we have observed that SystemView cannot communicate with the target when using channel 0.If we configure SystemView to use any RTT channel above 0, communication with the target works as expected.
Could you please confirm whether SystemView is unable to use RTT channel 0, or if there are additional configurations required to enable this functionality?
Thanks in advance for your support!