[ABANDONED] RTT with Artery AT32F437

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] RTT with Artery AT32F437

    Hello!

    I migrage my project from STM32F413 to AT32F437.

    My RTT output stopped working.
    The same project, builded for STM works fine with RTT.
    The debug settings are the same, except for the microcontroller type.
    RTT version: 7.98e

    What could be the problem?

  • Turnaev wrote:

    I migrage my project from STM32F413 to AT32F437.

    My RTT output stopped working.
    The same project, builded for STM works fine with RTT.
    The debug settings are the same, except for the microcontroller type.
    RTT version: 7.98e

    What could be the problem?
    Log from STM.
    Log from Artery.
    Debug config STM.
    Debug config Artery.
    Images

    • AT debug config.jpg

      97.51 kB, 969×806, viewed 2,553 times

    • AT log.jpg

      112.59 kB, 648×1,039, viewed 970 times

    • STM debug config.jpg

      91.67 kB, 968×765, viewed 3,094 times

    • STM log.jpg

      171.76 kB, 740×1,014, viewed 2,641 times

  • Hello,

    Please note that thread bumping is against forum rules.
    This will be the only and last warning as you have violated that rule twice already..

    Additionally this is not a support forum so there is no guarantee that you will receive an answer. If you require support from SEGGER please use our official channels as mentioned below.

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.