How to debug using J-Link edu mini along with NXP's S32DS

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • How to debug using J-Link edu mini along with NXP's S32DS

    Hi,
    I have bought a J-Link EDU mini to learn the development of NXP's S32k3 microcontroller. I am using the NXP S32 Development Studio.
    I have created my development board and populated it with JTAG. I can successfully flash the target board using J-Flash Lite software. I want to know how to debug the target controller using the J-Link EDU mini debugger.
    Any help is appreciated.

    Regards,
    Pratik
  • Hello,

    Unfortunately, we do not have experience debugging with the NXP S32 Development Studio either.

    Below is a link to a list of supported IDEs and instructions on how to set them up for debugging with Jlink:
    Supported IDEs

    Best regards,
    Simon
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.