[ABANDONED] SES becomes unresponsive when starting debug

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] SES becomes unresponsive when starting debug

    I'm working with the NXP iMXRT1011 chip using Segger Embedded Studio. For debugging. I managed to get the SVD file (MIMXRT1011_Registers.svd, dated August 2022) which was included in an installation package Rowley Associates IDE. However I encountered an issue when using that SVD file during debugging, every time I selected the DMA0 module for examination, Segger IDE becomes completely unresponsive when debugging is started, Windows task manager shows that memory usage shot up to over 250MB, The only way to get out of the situation is to power down the board, and when I did this sometimes SES will just throw 'JLINK ERROR' message and then quits.

    Does this sounds like an issue that can arise due to a problem with the SVD file? Or maybe something else?

  • Hello,

    Thank you for your inquiry.
    Such an issue is not known to us.
    Some svd files are written in a very nested manner so it is possible that it might take for some of them more resources than usual to unroll them.

    Could you share the svd file for reference?

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.