Hello,
I am developing the cortex-A53 based FPGA system.
If I enter connect command on JLink Commander Utility, then it scans the ROM Table inside coresight SoC600.
But, it stops the ROM Table scan immediately and the JLink utility prints the connection fail message
(refer to the 1st attached image)
When I tested it with openocd, all ROM Table entries were scanned well without connection fail.
The ROM Table structure is as follows.
(refer to the 2nd attached image)
In my opinion, if some entries are not present in the middle position of table like the picture above, it seems to stop the searching even though there are some ROM entries later.
I am using the latest jlink utility 7.84d.
Is there any solution to fix it up ?
Thank you in advance.
I am developing the cortex-A53 based FPGA system.
If I enter connect command on JLink Commander Utility, then it scans the ROM Table inside coresight SoC600.
But, it stops the ROM Table scan immediately and the JLink utility prints the connection fail message
(refer to the 1st attached image)
When I tested it with openocd, all ROM Table entries were scanned well without connection fail.
The ROM Table structure is as follows.
(refer to the 2nd attached image)
In my opinion, if some entries are not present in the middle position of table like the picture above, it seems to stop the searching even though there are some ROM entries later.
I am using the latest jlink utility 7.84d.
Is there any solution to fix it up ?
Thank you in advance.