I'm using the newest J-Flash Software V7.84b (but this behavior I also can see on e.g. 6.80d)
In case of saving the cfg file with the following name I get an error:
TEST_TEST_V1.0.3-rc.4_BL_V1.0.1-rc.2.cfg

"Could not save file [C:\Users...\TEST_TEST_V1.0.3-rc.4_BL_V1.0.1-rc\Device.pex] Path not found!"

In case of using underlined instead of dots everything is ok:
TEST_TEST_V1_0_3-rc_4_BL_V1_0_1-rc_2.cfg

It seems that there is a problem with path / dots / ...

Thank you in advance.

Hi Fabian,

here is the step by step procedure, hopefully you can reproduce it on your side (done with V7.84.b).

The *.jflash file is located here:
"C:\P4\flasher_test\test\REL_V2.0.3-rc.4\hex\Segger Flasher\STM32L071RB.jflash"

The data file is located in the parent folder:
"C:\P4\flasher_test\test\REL_V2.0.3-rc.4\hex\V2.0.3-rc.4_BL_V1.0.1-rc.2.hex"

By trying to save the config-file via "File->Save Config Flasher File" to the following folder:
"C:\P4\flasher_test\test\REL_V2.0.3-rc.4\hex\Segger Flasher\V2.0.3-rc.4_BL_V1.0.1-rc.2.cfg"

I'm getting this Error:
"Could not save file [C:\P4\flasher_test\test\REL_V2.0.3-rc.4\hex\Segger Flasher\V2.03-rc.4_BL_V1.0.1-rc\Device.pex] Path not found"



Marco