[SOLVED] Support for how to setup Flasher Pro to Infineon TC387QP160F300SAE micro.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Support for how to setup Flasher Pro to Infineon TC387QP160F300SAE micro.

    I have tried to figure out the setup connections & create new project for Infineon TC387QP160F300SAE microcontroller.
    The device is supported by Flasher Pro (according Segger web site), but is not appearing in selection target list, during creating new project.
    I`m using the last J-Flash version784b software and the Flasher Pro programmer updated to the last firmware.
    Did someone of you experiences this kind of issue? And what was the solution.

    Thank you in advance.

    The post was edited 1 time, last by iole ().

  • Hello,

    The Infineon TriCore MCUs are supported via the Universal Flash Loader Configurator instead of J-Flash.

    Best regards
    Arne
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.