nRF52832 Tracing & Soft resets

    This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

    • nRF52832 Tracing & Soft resets

      I'm collecting trace data using J-Trace and Ozone. It is meant for Code Coverage purposes and our test procedures involve several Soft Resets. After a Soft Reset the orange TRACE LED on J-Trace is active, however Ozone stops receiving trace data. Is there a ways for Ozone to keep collecting data after a Soft Reset ?
    • Hello,

      Thank you for your inquiry.
      Arm tracing was not designed to survive resets. So the answer is no.
      What you could try is to halt the debug session after reset and resume it in Ozone. That might work. But any data before that point would be gone.

      Best regards,
      Nino
      Please read the forum rules before posting.

      Keep in mind, this is *not* a support forum.
      Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
      Should you be entitled to support you can contact us via our support system: segger.com/ticket/

      Or you can contact us via e-mail.