Using JScope v7.64c and JLink-Ultra+, I am trying to capture some data from my Apollo3 target. The target is set up and SystemView works well with it, however, when I request JSCope to start recording data I get an error "Could not start data reading: Unspecified error."

Also, I have noted that the configuration is not restored when I save and load the project. This means having to set the options each time I start JScope. In fact, the options are not even saved when the options dialog is closed and then re-opened.

I really need to use this tool so any help would be much appreciated.

@Matthias Excuse my slow response, I did not get a notification from the forum about your post.

I am using JScope V7.64e

Regards,
Sid