I am using clion with JLink EDU to debug rp2040 target.
In clion I have a debug configuration that launches JLinkGDBServerCLExe (Linux x64, tgz, v7.58c) with the following arguments:
-select USB -device RP2040_M0_0 -endian little -if SWD -speed 1000 -noir -nogui -speed 4000 -noLocalhostOnly
The problem I'm seeing is that every time I start a new debug session I get a prompt reminding that this is JLink EDU version that cannot be used for commercial purposes- even when I check "don't show again today", the next time I start debug session I get the prompt.
In clion I have a debug configuration that launches JLinkGDBServerCLExe (Linux x64, tgz, v7.58c) with the following arguments:
-select USB -device RP2040_M0_0 -endian little -if SWD -speed 1000 -noir -nogui -speed 4000 -noLocalhostOnly
The problem I'm seeing is that every time I start a new debug session I get a prompt reminding that this is JLink EDU version that cannot be used for commercial purposes- even when I check "don't show again today", the next time I start debug session I get the prompt.