[SOLVED] How to find, start, and open J-Scope ?

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] How to find, start, and open J-Scope ?

    Hello all,

    I am trying to use the J-Scope, however, I am not sure where the actually program is, nor how to start the program? <X I am using J-Link V6.40 with the uVision5 and ARM M0 based uC on windows 10.

    Any help is much appreciated!

    Best.

  • Hello,

    J-Scope has been included in the J-Link Software and Documentation pack which you can download at:
    segger.com/downloads/jlink/

    You can find the executable at the default installation path: C:\Program Files (x86)\SEGGER\JLink

    Best regards,
    Matthias
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.

  • Hello,

    yes, this should work.

    You can find more information about J-Scope in the wiki.
    wiki.segger.com/UM08028_J-Scope

    Best regards,
    Matthias
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.