[SOLVED] J-scope crashes when loading .out

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] J-scope crashes when loading .out

    Hi,
    When I load the *.out file, Jscope crashes during "finishing symbols" phase.
    With the 32 bit version V6.11m it didn't happen.
    The crash happens both in V756d 32 and 64 bit.
    Any hint on how to debug the issue?
    Is it possibile that since the .out file does not start at zero the scope crashes?

    Thanks and K.R.

  • Hello,

    such an issue is not known to us.

    Would it be possible for you to provide the .elf file for us to investigate the issue?

    Best regards,
    Matthias
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.

  • What I meant is the .out file of course.
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.

  • Hello,

    that would be very helpful, thank you.

    Best regards,
    Matthias
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.

  • Hello,

    a similar sounding issue was just fixed and will be released with the next version of the J-Link software package scheduled for some time next week.

    Once released, could you give it a try and tell me if it solves the issue?

    Best regards,
    Matthias
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.