[SOLVED] JLink Can`t connect to IoT Device Bosch XDK

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] JLink Can`t connect to IoT Device Bosch XDK

    Hi All!

    I would like to establish connection and Debug an Embedded device (Bosch XDK) via JTAG, but there is a problem with the connection according to J-Link Commander:

    Connecting to target via JTAG
    InitTarget() start
    InitTarget() end
    Could not measure total IR len. TDO is constant high.




    Please find the log generated here: log.txt

    Did anyone else experienced similar problems? Please help me find what is the issue.

    Best,
    Daniel

  • Hi Daniel,
    Thank you for your inquiry.
    There is no such issue known to us.

    From first glance this looks like a setup issue.
    Could you please follow the troubleshooting article on the page linked below?
    wiki.segger.com/J-Link_cannot_…the_CPU#Target_connectionCould you please make sure that all cables used are functioning properly and connected correctly?

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.