Hi,
once I built my project and got my .hex file, I have converted the file to .coe format (Xilinx coefficients file). I have realized that the obtained .coe file has a big-endian format, but I need a little-endian format.
Is it possible to change the endianness of the .hex output file from our project options in SES? I have been searching in the manual and found some additional options (-little_endian, -EL,..) but it seems that I am not able to set these options properly...
Thanks in advance,
Ricardo
once I built my project and got my .hex file, I have converted the file to .coe format (Xilinx coefficients file). I have realized that the obtained .coe file has a big-endian format, but I need a little-endian format.
Is it possible to change the endianness of the .hex output file from our project options in SES? I have been searching in the manual and found some additional options (-little_endian, -EL,..) but it seems that I am not able to set these options properly...
Thanks in advance,
Ricardo