Hi
I am using the Flasher ATE Gang programmer and have experienced an issue when using the #ERASE command.
When I have used the #ERASE command to erase the flash I can't program the target and get the following error description "#ERR255:Failed to read back RAMCode for verification"
However when I select "clip Erase" in J-Flasher and use the #auto command to program a target that haven't been erased with #ERASE the programming succeed. But if I uncheck the program box under Project setting -> Production and only check the Erase box the result is the same as the #erase command.
If I use JTAG/SWD Debug Probe I have no trouble programming the target after using the #erase command
Can you please tell me what to do in order to program the target with the Flasher ATE Gang programmer after it has been erased with the #erase command.
Kind regards,
Jakob
I am using the Flasher ATE Gang programmer and have experienced an issue when using the #ERASE command.
When I have used the #ERASE command to erase the flash I can't program the target and get the following error description "#ERR255:Failed to read back RAMCode for verification"
However when I select "clip Erase" in J-Flasher and use the #auto command to program a target that haven't been erased with #ERASE the programming succeed. But if I uncheck the program box under Project setting -> Production and only check the Erase box the result is the same as the #erase command.
If I use JTAG/SWD Debug Probe I have no trouble programming the target after using the #erase command
Can you please tell me what to do in order to program the target with the Flasher ATE Gang programmer after it has been erased with the #erase command.
Kind regards,
Jakob
The post was edited 1 time, last by janrr ().