[SOLVED] MPC5777C and Segger

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] MPC5777C and Segger

    Dear Mr / Mrs,

    I have segger Jlink debugger probe. Can I use NXP MPC5777C for debugging and programming? Is NXP MPC5777C as compatiable mcu for Segger probe. I could'nt see NXP MPC5777c on supported list.

    Best Regards.

    The post was edited 2 times, last by atabey1567 ().

  • Hi,
    Thank you for your inquiry.

    Regarding debugging:
    We do not officially support the Power architecture for debugging with J-Link and do not have any plans for supporting it.
    The reason is that the demand for debugging support on these devices is very small,
    but the effort to support Power devices is usually pretty high.

    Regarding Programming:
    We do provide programming support for multiple Power architecture devices, including the MPC56xx series:
    segger.com/supported-devices/search/mpc5

    However, as already mentioned, this does not include debug support.

    Should you still be interested in programming support via Flasher,
    I would forward you to our Flasher team regarding flash programming support for the MPC57xx devices.

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.