Hi everyone,
I try to flash my custom PCB board bearing the STM32WLE5JC, ARM Cortex M4 MCU. I use the J-LINK Plus. While trying to flash my PCB through STM32CubeIDE I receive the following errors:
When I press OK, the following "Target device settings" pops up:
but before insert device and core info the following error pops up:
I tryied to connect the debugger with the target through the JLINK commander but I fail. The debug window sais "Failed to power the DAP"
I confirm that the probe is updated with the latest FW version
Any suggestions? Does J-Link supports STM32WLE5JC MCU?
Thanks
Nick
I try to flash my custom PCB board bearing the STM32WLE5JC, ARM Cortex M4 MCU. I use the J-LINK Plus. While trying to flash my PCB through STM32CubeIDE I receive the following errors:
When I press OK, the following "Target device settings" pops up:
but before insert device and core info the following error pops up:
I tryied to connect the debugger with the target through the JLINK commander but I fail. The debug window sais "Failed to power the DAP"
I confirm that the probe is updated with the latest FW version
Any suggestions? Does J-Link supports STM32WLE5JC MCU?
Thanks
Nick