[SOLVED] J-Link EDU for Arduino Nano 33 Ble sense using Keil MDK

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] J-Link EDU for Arduino Nano 33 Ble sense using Keil MDK

    I tried to use J-LInk EDU to debug Arduino Nano 33 Ble sense board. Using Keil MDK, I set up the "Device" as NRF52840_xxAA and use the real debugger J-Link EDU. But the problem is that during debugging, the event counters, like CPICNT and LSUCNT, will overflow. I have checked the debugger configuration again and again but could not figure out where the problem is. The following is the configuration screenshot for J-Link EDU.

  • Hi,
    Thank you for your inquiry and sorry for the delay in response.

    From what we can see, this does not seem like a J-Link specific issue.
    You would have to contact KEIL support regarding this.

    We will close this thread now.

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.