[ABANDONED] Segger J-link GDB server lost connection to the target and debug session has been terminated.

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Segger J-link GDB server lost connection to the target and debug session has been terminated.

    I'm using a J-Link Base with Eclipse trying to load/debug a Kinetis K64F board.
    Mostly it works extremely well, however...
    It very often fails to program the device and I get the error dialog below.
    Sometimes I have to power-cycle the device and retry a dozen times, other times it just works.
    Any hints as to what might be causing this intermittent behavior?
    Its very painful!
    Thanks in advance,
    Best Regards, Dave

    PS: Windows 10, JLink_Windows_V722b driver/gdb/firmware package installed.
    Images

    • 20210618_Segger_programming_failure.PNG

      55.43 kB, 855×671, viewed 440 times

    The post was edited 2 times, last by DaveN: clarification ().

  • Hi,
    Thank you for your inquiry.
    Such an issue is not known to us.

    Could you provide us with a sample project this issue is reproducible with,
    including step by step instructions on how to reproduce it?

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.