I have problems to run and debug an example on one of my targets
Programmer: J-Link plus - connected via SWD-Interface (Segger 6-pin adapter)
Environment: using SES V5.44
1. Target: Nordic nRF52832 on a UTOVERTEK UTO-NBL-52A Eval-Board
2. Target: Nordic nRF52832 on a custom PCB
Source/Example: ble_app_uart_pca10040_s1321 from Nordic SDK 17.0.2
The source code compiles without any problems and I'm able to download and debug the code on target #1 (UTO) right away from SES.
When trying the same with target #2, compile the code with F7 then run it with F5, SES pops up with "failed to download application, Generic error"
Connecting J-Link works, no problems.
Also the "target connection properties" seem to be ok, but one thing bothers me: it reports the target as "Cortex-M0" - but the nRF52832 is a Cortex-M4
But: using the older "nrfGo Studio" I can successfully connect to target #2 and read/write/verify softdevice and applications
any ideas what might be wrong here ?
thanks, Matthias
Programmer: J-Link plus - connected via SWD-Interface (Segger 6-pin adapter)
Environment: using SES V5.44
1. Target: Nordic nRF52832 on a UTOVERTEK UTO-NBL-52A Eval-Board
2. Target: Nordic nRF52832 on a custom PCB
Source/Example: ble_app_uart_pca10040_s1321 from Nordic SDK 17.0.2
The source code compiles without any problems and I'm able to download and debug the code on target #1 (UTO) right away from SES.
When trying the same with target #2, compile the code with F7 then run it with F5, SES pops up with "failed to download application, Generic error"
Connecting J-Link works, no problems.
Also the "target connection properties" seem to be ok, but one thing bothers me: it reports the target as "Cortex-M0" - but the nRF52832 is a Cortex-M4
But: using the older "nrfGo Studio" I can successfully connect to target #2 and read/write/verify softdevice and applications
any ideas what might be wrong here ?
thanks, Matthias