[ABANDONED] Maximum baud rate of J-Link VCOM

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] Maximum baud rate of J-Link VCOM

    How fast is the maximum baud rate of J-Link VCOM?

    When I set the baud rate of J-Link VCOM to 921600bps, I could not communicate normally. Communication was successful at 115200bps or less.

    I am using version 7.20a.
  • Hello,

    It depends on the actual model.
    On most it is done in software, on some there is a dedicated hardware UART available.
    Therefore, the achievable baudrates (and the max. baudrate) depends on the actual model and HW version.

    If you post your S/N, I can tell you the VCOM parameters.

    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.