Greetings everyone,
I am wondering if it is possible to use Ozones trace features (timeline, code coverage...) with a reflashed ST-Link to a J-Link.
In my example, I am using a nucleo-F767ZI board from ST. The on-board ST-Link has been reflashed. Everything works fine in Ozone
except from the trace features. The instruction trace always says "Instruction trace disabled". As I read in this forum, SWO is not enough to
use this trace. For that I need trace pins or trace buffer. Unfortunately, the trace pins of the F767 are not connected to the onboard ST-Link.
My question is, when using an external, reflashed ST-Link and connecting to the corresponding 5 trace pins, is the reflashed J-Link firmware capable
of using the trace pins or is this only possible with a J-Trace Pro. In addition higher boards like the STM32H7 series feature ETF to be used as trace buffer.
In that case, can I use a reflashed ST-Link for tracing via buffer?
With best regards
I am wondering if it is possible to use Ozones trace features (timeline, code coverage...) with a reflashed ST-Link to a J-Link.
In my example, I am using a nucleo-F767ZI board from ST. The on-board ST-Link has been reflashed. Everything works fine in Ozone
except from the trace features. The instruction trace always says "Instruction trace disabled". As I read in this forum, SWO is not enough to
use this trace. For that I need trace pins or trace buffer. Unfortunately, the trace pins of the F767 are not connected to the onboard ST-Link.
My question is, when using an external, reflashed ST-Link and connecting to the corresponding 5 trace pins, is the reflashed J-Link firmware capable
of using the trace pins or is this only possible with a J-Trace Pro. In addition higher boards like the STM32H7 series feature ETF to be used as trace buffer.
In that case, can I use a reflashed ST-Link for tracing via buffer?
With best regards