This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.



    I need some help regarding the JTAG_TRST signal.
    I would like to know if the signal is used during programming, as I understand is the pin mostly used during debugging but can can't find anywhere it says it isn't used during programming.
    By programming I mean the segger function "#auto" and by "used" I mean is the signal pull low by the segger flasher ATE during programming?
    I hope you understand my question.

    Kind regards,
  • Hi Jakob,

    There are 2 signals that sound very similar:
    This is the reset pin of the MCU.
    This signal is used during programming.

    Test-logic-reset. Nowadays, most MCus do not even provide this signal. It is not really used during programming. So you can usually safely leave out this signal.
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.