Hi, I have two debuggers: J-Link Base 10.1 and J-Link EDU 11.0. The first one (Base) works more or less fine, but the second (EDU) displays a message box:
"ETB selected as trace source, but current device does not have an ETB"
The eval board is TI LCDK OMAP-L138 (2 cores: ARM9 (arm926ej-s) and DSP).
IDE: IAR 8.5
Firmware was updated using J-Link V6.98 drivers.
How can I disable these messages since they make debugging impossible (with EDU)? These messages appear every time a line of code is executed.
Why debugger behavior is different?
"ETB selected as trace source, but current device does not have an ETB"
The eval board is TI LCDK OMAP-L138 (2 cores: ARM9 (arm926ej-s) and DSP).
IDE: IAR 8.5
Firmware was updated using J-Link V6.98 drivers.
How can I disable these messages since they make debugging impossible (with EDU)? These messages appear every time a line of code is executed.
Why debugger behavior is different?