[ABANDONED] SEGGER J-Flash Lite V6.94 - Connecting to J-Link - Connecting to target - ERROR: Could not connected

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [ABANDONED] SEGGER J-Flash Lite V6.94 - Connecting to J-Link - Connecting to target - ERROR: Could not connected

    Hello Team,

    I am writing here to ask you to help me out, how to resolve the SEGGER J-Flash Lite V6.94 connection issue with the evaluation board - ERROR: Could not connected

    I am using the eval board kit of TLE9879 with SEGGER J-Flash Lite V6.94 to flash my application but could not able to connect and before flashing I tried to erase the chip and I got an ERROR: Could not connect. I feel memory get locked.


    please suggest to me if you have a solution for the above issue.

  • Hi,
    Thank you for your inquiry.
    There is no issue known to us with TLE9879 and J-Flash Lite.

    Could you please
    1) try the latest J-link Software Pack:
    segger.com/downloads/jlink#J-L…twareAndDocumentationPack
    2) follow the troubleshooting article on the page linked below
    and send us a screenshot of the entire J-Link Commander output?
    wiki.segger.com/J-Link_cannot_…the_CPU#Target_connection
    3) tell us which evaluation board you are using exactly?
    4) send us a J-Link log file? How to enable:
    wiki.segger.com/J-Link_DLL#Enable_J-Link_Log_File

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.