Hello,
We recently purchased a JLINK Plus compact debug probe in order to attempt and debug an RV32 processor that has no System bus access Or Program Buffer but only allows memory accesses using Abstract Commands - Access Memory (as portrayed in the Debug Spec)
As such I can successfully write/read CSRs, halt and all of the basic functionality but cannot read/write memory. If we connect OpenOCD to JLINK we are able to Load a binary and access memory successfully as expected (using riscv set_mem_access abstract)
Unfortunately, this doesn't allow us to use Ozone, which is the main reason we purchased the probe.
Is there a way to use such access to memory by default? If not, will it be implemented anytime soon?
Thanks,
Mario.
We recently purchased a JLINK Plus compact debug probe in order to attempt and debug an RV32 processor that has no System bus access Or Program Buffer but only allows memory accesses using Abstract Commands - Access Memory (as portrayed in the Debug Spec)
As such I can successfully write/read CSRs, halt and all of the basic functionality but cannot read/write memory. If we connect OpenOCD to JLINK we are able to Load a binary and access memory successfully as expected (using riscv set_mem_access abstract)
Unfortunately, this doesn't allow us to use Ozone, which is the main reason we purchased the probe.
Is there a way to use such access to memory by default? If not, will it be implemented anytime soon?
Thanks,
Mario.