I have downloaded J-Link V6.95c Beta version to try debugging my rpi pico with J-Link Edu 9.2
Problem is that I get an error message saying 'Connected JLink does not support SWD multi-drop'
do I need to buy a new J-Link Edu or is this a software issue?
Thank you,
Michael
J-Link>connect
Device "RP2040_M0_0" selected.
Connecting to target via SWD
ConfigTargetSettings() start
J-Link script: ConfigTargetSettings()
ConfigTargetSettings() end
InitTarget() start
InitTarget() end
Found SW-DP with ID 0x0BC12477
DPIDR: 0x0BC12477
Scanning AP map to find all available APs
AP[1]: Stopped AP scan as end of AP map has been reached
AP[0]: AHB-AP (IDR: 0x04770031)
Iterating through AP map to find AHB-AP to use
AP[0]: Core found
AP[0]: AHB-AP ROM base: 0xE00FF000
CPUID register: 0x410CC601. Implementer code: 0x41 (ARM)
Found Cortex-M0 r0p1, Little endian.
****** Error: Specific core setup failed.
Cannot connect to target.
Problem is that I get an error message saying 'Connected JLink does not support SWD multi-drop'
do I need to buy a new J-Link Edu or is this a software issue?
Thank you,
Michael
J-Link>connect
Device "RP2040_M0_0" selected.
Connecting to target via SWD
ConfigTargetSettings() start
J-Link script: ConfigTargetSettings()
ConfigTargetSettings() end
InitTarget() start
InitTarget() end
Found SW-DP with ID 0x0BC12477
DPIDR: 0x0BC12477
Scanning AP map to find all available APs
AP[1]: Stopped AP scan as end of AP map has been reached
AP[0]: AHB-AP (IDR: 0x04770031)
Iterating through AP map to find AHB-AP to use
AP[0]: Core found
AP[0]: AHB-AP ROM base: 0xE00FF000
CPUID register: 0x410CC601. Implementer code: 0x41 (ARM)
Found Cortex-M0 r0p1, Little endian.
****** Error: Specific core setup failed.
Cannot connect to target.