I upgraded to J-Link Commander V6.94b. I have a JTrace Pro HW version 2.0.
Previously, I had no trouble using the Segger JTAG with the TM4C1290NCPDT custom board. I am able to flash/debug this custom target using the TI JTAG programmer. But with the JLink commander, it is unable to connect to the target. Please see attached snapshot of the command window. I need this resolved ASAP.
Thanks,
Priya
Previously, I had no trouble using the Segger JTAG with the TM4C1290NCPDT custom board. I am able to flash/debug this custom target using the TI JTAG programmer. But with the JLink commander, it is unable to connect to the target. Please see attached snapshot of the command window. I need this resolved ASAP.
Thanks,
Priya