Dear Segger Support,
I am facing problems when running J-Scope when performing a target selection. Once I try to set a target I receive a J-Link ARM error (see attachment). I confirm by clicking OK twice and see an empty device selection (see attachment). When I keep the device as "unspecified", I am able to continue. Once I try to Start sampling, I see the J-Link ARM error again, followed by lots of other different errors/warnings.
Is this a known bug?
Thanks in advance.
Philipp
![](https://forum.segger.com/index.php/Attachment/4539-dll-png/?s=9fb9e8539db851c4f54b73039f5ae167ebdae3ea)
I am facing problems when running J-Scope when performing a target selection. Once I try to set a target I receive a J-Link ARM error (see attachment). I confirm by clicking OK twice and see an empty device selection (see attachment). When I keep the device as "unspecified", I am able to continue. Once I try to Start sampling, I see the J-Link ARM error again, followed by lots of other different errors/warnings.
Is this a known bug?
Thanks in advance.
Philipp