Windows 7
Atollic 9.3
Debug hardware: j-link ULTRA+
GDB: V680c JLinkGDBServerCL.exe
Micro controller: STM32F091RC
If we delete the flash with the command "FlashStatus = FLASH_ErasePage( address )" the flash in this page should be 0xFF. But the whole flash content is not updated in the memory browser. I have tried it with other versions of the JLinkGDBServerCL.exe with no success.
If I make the same procedure with the ST-Link/V2 is works perfectly.
I would be grateful for any hint.
Atollic 9.3
Debug hardware: j-link ULTRA+
GDB: V680c JLinkGDBServerCL.exe
Micro controller: STM32F091RC
If we delete the flash with the command "FlashStatus = FLASH_ErasePage( address )" the flash in this page should be 0xFF. But the whole flash content is not updated in the memory browser. I have tried it with other versions of the JLinkGDBServerCL.exe with no success.
If I make the same procedure with the ST-Link/V2 is works perfectly.
I would be grateful for any hint.