[SOLVED] RTT On Bare Metal, no SDK

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] RTT On Bare Metal, no SDK

    Hi,

    I would like to setup on RTT for my debugging purposes instead of printing to a uart. I am using a nordic nrf52840, no SDK, segger embedded studio, J-Link debugger. Is it possible to do this, or do I need an SDK to use RTT? Also, are there instructions somewhere on how to set this up?

    Thanks!
  • Hi,
    Thank you for your inquiry.
    I moved this thread to the correct sub-forum.

    To answer your questions:
    The SDK is not required for RTT.

    You can probably find all required information here:
    wiki.segger.com/RTT

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.