Hi,
I would like to setup on RTT for my debugging purposes instead of printing to a uart. I am using a nordic nrf52840, no SDK, segger embedded studio, J-Link debugger. Is it possible to do this, or do I need an SDK to use RTT? Also, are there instructions somewhere on how to set this up?
Thanks!
I would like to setup on RTT for my debugging purposes instead of printing to a uart. I am using a nordic nrf52840, no SDK, segger embedded studio, J-Link debugger. Is it possible to do this, or do I need an SDK to use RTT? Also, are there instructions somewhere on how to set this up?
Thanks!