[SOLVED] Memory test of MCIMX6S5

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Memory test of MCIMX6S5

    Hi,

    It's my intention to use the J-Link Commander to run a memory test on the NXP MCIMX6S5. This is supported as a 'known' device.

    Does using the 'Device' command (selecting MCIMX6S5) configure the MCIMX6S5 to use the JTAG interface? Do I just need a J-Link and the SDK or is there anything else required? It's just that someone told me I would need some form of device specific configuration file from the silicon vendor.


    Thanks.

  • Hi,
    Thank you for your inquiry.

    Leelancs wrote:

    Does using the 'Device' command (selecting MCIMX6S5) configure the MCIMX6S5 to use the JTAG interface?
    The device interface can be selected by the user directly, e.g. via command line: wiki.segger.com/J-Link_Commander#-If
    or via the "si" command: wiki.segger.com/J-Link_Commander#si

    What you require

    Leelancs wrote:

    Do I just need a J-Link and the SDK or is there anything else required?
    It depends on what kind of test you want to do.
    If you simply want to read some flash/RAM, the easiest way would probably be to use the J-Link Commander.
    If you want to have a solid/complex test setup we would recommend the SDK.

    Does this answer your questions?

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/
    Or you can contact us via e-mail.