[SOLVED] J-link adapter for 6 pin flat cable

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] J-link adapter for 6 pin flat cable

    I'm looking for the attached adapter board which allows connecting the Segger J-link to a 6pin FPC flat cable as shown. Anyone know where to to find this adapter? I've searched J-link adapters, but can't find anything similar (the one shown here was provided to a friend but he doesn't know where from). I'm trying to connect my Segger J-link to my Nordic PCB and program the PCB (the PCB has this 6 pin flat connector).

    Thanks!
    Images
    • adapter.jpg

      116.54 kB, 690×644, viewed 453 times
  • Hi,
    Thank you for your inquiry.

    This adapter is most likely custom made, as it is not a usual standard.
    You would probably have to design/make one yourself.

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.
  • Hi,
    You're welcome.

    We will close this thread now.

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.