[DUPLICATE] A newbie step

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [DUPLICATE] A newbie step

    Hello All

    I have the sensor board that I can program via the J-Link edu and sagger embedded studio for ARM, indeed the dev board (AI Sensor board) is based on ARM, namely M3. Therefore, I am looking at basic introduction material how to get going, namely how to make a simple hello world and save it, eventually compile it and upload on the dev board.

    Looking forward to your comments, ideas.

    BEST.
  • Hello,

    See your other post for more details on how to get started.
    emStudio, arm and ETA

    We will close this thread now to avoid duplicate threads.

    Best regards,
    Nino
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.