Hello all,
I am moving to the arm along with the eta chip that can be programmed via the emStudio, so I am wondering how to work with the ETA AI Sensor Board , has any of you had a go with it?
The library is out there, however, I am new to the emStudio so was wondering where to get a basic overview of how to flash a basic "blink" on that board, it is accessible via usb...
Looking forward for your comments, suggestions...
BEST.
I am moving to the arm along with the eta chip that can be programmed via the emStudio, so I am wondering how to work with the ETA AI Sensor Board , has any of you had a go with it?
The library is out there, however, I am new to the emStudio so was wondering where to get a basic overview of how to flash a basic "blink" on that board, it is accessible via usb...
Looking forward for your comments, suggestions...
BEST.