There is a GUI which pops up on start-up / connect attempt, when JLink cannot open the probe, it's asking for probe id , or IP address , or serial etc..
When invoking JLinkExe you sort of can disable GUI, and you can pass on command line where you want to connect, which probe.
But if JLink gets invoked through dll/ so, by an IDE, is it possible to pre-configure / save JLink params somewhere, like local init file?
I need to insert an IP address of the probe, so I do not have to insert it every time I start debug session - this currently does not get saved, in the Segger' Gui dialog.
Any way currently I can do this, may be like with .gdbinit type of hidden file..?
When invoking JLinkExe you sort of can disable GUI, and you can pass on command line where you want to connect, which probe.
But if JLink gets invoked through dll/ so, by an IDE, is it possible to pre-configure / save JLink params somewhere, like local init file?
I need to insert an IP address of the probe, so I do not have to insert it every time I start debug session - this currently does not get saved, in the Segger' Gui dialog.
Any way currently I can do this, may be like with .gdbinit type of hidden file..?