[SOLVED] Programming a STM32WB55 dongle from Nucleo Pack directly

This site uses cookies. By continuing to browse this site, you are agreeing to our Cookie Policy.

  • [SOLVED] Programming a STM32WB55 dongle from Nucleo Pack directly

    Hello,
    I've got a STM32WB55 Nuleo Pack with a Nucleo Board and an USB Dongle.
    Programming the Nucleo Board is simple as the intergrated ST-Link can be changed to a JLink very easily.
    But what's about the dongle? Is there an similar easy way to program the controller on this dongle?
    I don't like to use the STMQube -Software only for proramming the controller.

    73 de Kai DL1GJJ
  • Hello,

    What is on the dongle?
    Also an ST-LINK V2/V2-1?


    BR
    Alex
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.
  • Hi,
    Unfortunately, the conversion tool does not work on ST-Link V3.

    Best regards,
    Fabian
    Please read the forum rules before posting.

    Keep in mind, this is *not* a support forum.
    Our engineers will try to answer your questions between their projects if possible but this can be delayed by longer periods of time.
    Should you be entitled to support you can contact us via our support system: segger.com/ticket/

    Or you can contact us via e-mail.