Hi
I'm a newcomer to the capabilities of Jlink, and am investigating the possibility of using Jlink (and/or associated utilities) to set the RTC within an NXP K60. On the surface of it, I think it ought to be possible using a (dynamically created/executed) Jlink script, but I'd appreciate a sanity check on this approach before I waste too much time on a possibly flawed approach.
I am seeing some unexpected behaviour when attempting to read the related address ranges using commander (see attached) which may be indicative of my not having configured the device suitably beforehand, but again, any guidance would be most appreciated.
David
I'm a newcomer to the capabilities of Jlink, and am investigating the possibility of using Jlink (and/or associated utilities) to set the RTC within an NXP K60. On the surface of it, I think it ought to be possible using a (dynamically created/executed) Jlink script, but I'd appreciate a sanity check on this approach before I waste too much time on a possibly flawed approach.
I am seeing some unexpected behaviour when attempting to read the related address ranges using commander (see attached) which may be indicative of my not having configured the device suitably beforehand, but again, any guidance would be most appreciated.
David