I test a samd51 cortex M4 with a J-Link Edu and Ozone and want to see the ETB data. Is this possible and what must I do to activate it on the mcu?
I am also a little bit irritated because if I connect with J-Link I get ROMTbl[0] @ 41003000 after the scan but if I read the address of the ETB on the target I get 0x41002000.
Must I change the address in J-Link?
Thanks for help.
The reason I am doing this is, I want to see what a J-Trace can do what a J-Link can not.
I am also a little bit irritated because if I connect with J-Link I get ROMTbl[0] @ 41003000 after the scan but if I read the address of the ETB on the target I get 0x41002000.
Must I change the address in J-Link?
Thanks for help.
The reason I am doing this is, I want to see what a J-Trace can do what a J-Link can not.