Hi everyone,
I am trying to reflash my STM32F4Discovery (MB997C) to a J-Link OB, unfortunately I get the following error message:
[0] Quit
[1] Upgrade to J-Link
[2] Update J-Link firmware
[3] Restore ST-Link
Selection>1
Preparing for FW update (can take up to 10 seconds)...ERROR: Unsupported ST-LINK firmware
[0] Quit
[1] Upgrade to J-Link
[2] Update J-Link firmware
[3] Restore ST-Link
Selection>1
Preparing for FW update (can take up to 10 seconds)...Invalid handleERROR: Cannot find an ST-LINK, multiple ST-LINKs plugged in, or ST-LINK is in use
Relevant infos:
STM32F4Discovery (MB997C) - I tried both with and without the jumpers in place to connect the ST-Link to the target
STLink V2 Firmware version: V2J37S0
J-Link SW: V6.82f / V6.83c (both with the same result)
STLinkReflash_190812 (=latest)
Did anyone else experience this behaviour and somehow get the reflash to work?
Any help is greatly appreciated.
BTW thanks a lot to Segger for providing the possibility to evaluate their tools!
Best regards,
Thomas
I am trying to reflash my STM32F4Discovery (MB997C) to a J-Link OB, unfortunately I get the following error message:
[0] Quit
[1] Upgrade to J-Link
[2] Update J-Link firmware
[3] Restore ST-Link
Selection>1
Preparing for FW update (can take up to 10 seconds)...ERROR: Unsupported ST-LINK firmware
[0] Quit
[1] Upgrade to J-Link
[2] Update J-Link firmware
[3] Restore ST-Link
Selection>1
Preparing for FW update (can take up to 10 seconds)...Invalid handleERROR: Cannot find an ST-LINK, multiple ST-LINKs plugged in, or ST-LINK is in use
Relevant infos:
STM32F4Discovery (MB997C) - I tried both with and without the jumpers in place to connect the ST-Link to the target
STLink V2 Firmware version: V2J37S0
J-Link SW: V6.82f / V6.83c (both with the same result)
STLinkReflash_190812 (=latest)
Did anyone else experience this behaviour and somehow get the reflash to work?
Any help is greatly appreciated.
BTW thanks a lot to Segger for providing the possibility to evaluate their tools!
Best regards,
Thomas