Hi everyone,
I am trying to learn the basics of debugging using SEGGER. I am using a very simple blinky example to start learning debugging.
I have declare and initialize two variables x & y. When I run the debugger and use the "watch" window to monitor the value of each variable, I can see the y variable but neither the x or i variables.. It sais "symbol not found" as shown on screenshot_69
The strange thing is that if I initialize x=0 then I can see the x variable on "watch" window as shown on screenshot_70. But again I cannot see the i variable.
Moreover if I delete both x and y variables then I can monitor i variable while debugging as shown in screenshot_71.
I cannot figure out what I am doing wrong with the breakpoints.. Any help?
I am trying to learn the basics of debugging using SEGGER. I am using a very simple blinky example to start learning debugging.
I have declare and initialize two variables x & y. When I run the debugger and use the "watch" window to monitor the value of each variable, I can see the y variable but neither the x or i variables.. It sais "symbol not found" as shown on screenshot_69
The strange thing is that if I initialize x=0 then I can see the x variable on "watch" window as shown on screenshot_70. But again I cannot see the i variable.
Moreover if I delete both x and y variables then I can monitor i variable while debugging as shown in screenshot_71.
I cannot figure out what I am doing wrong with the breakpoints.. Any help?